Powder Switch

Most coating processes have interruptions, for example caused by a change of substrate or a  loading of a new robot program. Our soft powder makes it possible to obtain a stable once set powder flow without interruption upright. If you switch from the powder feed, such tubes are „empty blown“ by the carrier gas.

To avoid this loss of powder and re-stabilizing time when restarting, we complement your powder feeder with a soft powder and an additional container.
Controlled by manual or programmed signals directing pneumatically operated valves powder flow in either the main power to the consumer or to the recycling container whenever the process requires no powder. To not lose precious time still valuable powder. For optimum utilization of the powder is soft and movable constructed very close to the processing site positioned.


  • Gas-tight, regardless of the carrier gas pressure and -amount
  • Free recoil when switching, no spillover into the conveyor system
  • Maintenance free and easy to clean
  • Wear resistant even with abrasive powders
  • Retrofit and compatible with commercially available powder conveyors
  • Al-housing
  • Dimensions: 16 x 100 x 60 mm
  • Swagelok connections, either for powder hose 6/4, 5/3 or 4/2 mm
  • Pneumatic bypass of the powder stream
  • Maximum working pressure: 1 bar